MacBook Air 11" Mid 2011 AirPort/Bluetooth Card Replacement

Step 1 MacBook Air 11" Mid 2011 AirPort/Bluetooth Card Replacement

• Shut down and close your computer. Lay it on a soft surface top-side down.
• Remove the following ten screws:
• Two 8 mm 5-point Pentalobe screws
• Eight 2.5 mm 5-point Pentalobe screws
• The special screwdriver needed to remove the 5-point Pentalobe screws can be found .
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2

• Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• In this step you will disconnect the battery to help avoid shorting out any components during service.
• Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
• Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 6
• Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board.
• To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.
• Remove the AirPort/Bluetooth board from the Air.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview