MacBook Pro 15" Unibody Mid 2010 AirPort/Bluetooth Cable Replacement

Step 1 Lower Case

• Remove the following ten screws securing the lower case to the upper case:
• Three 13.5 mm (14.1 mm) Phillips screws.
• Seven 3 mm Phillips screws.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2

• Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.
• Remove the lower case and set it aside.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.
• Carefully peel the AirPort/Bluetooth ribbon cable off the top of the black plastic AirPort/Bluetooth housing.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off its socket on the AirPort/Bluetooth board.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview