Introduction
Charges battery and connects battery to logic board.
What you need
-
-
With the case closed, place the Unibody top-side down on a flat surface.
-
Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.
-
-
-
Remove the following eight screws securing the lower case to the chassis:
-
One 3 mm Phillips screw.
-
Three 13.5 mm Phillips screws.
-
Four 3.5 mm Phillips screws.
-
-
-
Remove the following screws securing the battery connector cover to the upper case:
-
One 2.5 mm Phillips screw.
-
Two 1.5 mm Phillips screws.
-
-
-
Remove the single 2.7 mm Phillips screw securing the battery cable cover to the upper case.
-
Lift the battery cable cover out of the upper case.
-
-
-
Using a spudger, pry the battery level indicator cable connector straight up off the logic board.
-
-
-
Pull the battery connector cable slightly toward the logic board to give yourself enough slack to grab the cable with your fingers.
-
Disconnect the cable by pulling it straight away from the logic board.
-
-
-
De-route the battery connector cable through the gap in the upper case and remove it from the computer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.