MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement

Step 1 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement

• Remove the eight 4 mm Phillips screws securing the lower case to the MacBook.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2




• The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.
• Slightly lift the lower case near the vent opening.
• Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.
• The location of these three clips is shown in the third picture.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• For precautionary purposes, we advise that you disconnect the battery connector from the logic board to avoid any electrical discharge. This step is optional and is not required.
• Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.
• It may be easier to use your fingernails to lift up on both sides of the connector.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.
• Carefully peel the AirPort/Bluetooth ribbon cable from its channel within the rear speaker assembly.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the right speaker.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview