Skip to main content

Canon PowerShot S400 Shutter Button Assembly Replacement

Views: 32

View statistics:

Past 24 Hours:
0
Past 7 Days:
0
Past 30 Days:
0
All Time:
32
Comments: 0

No one has left comments on this guide. Will you be first?

Go to guide comments
Completed: 0

No one has marked this guide "completed." Will you be the first?

Favorites: 0

No one has favorited (and subscribed to) this guide. Will you be the first?

Time Required: No estimate
Difficulty: Moderate
Canon PowerShot S400 Shutter Button Assembly Replacement

Introduction

Go to step 1 ↓

This guide provides instructions on how to replace the shutter button assembly on the Canon PowerShot S400.

    1. Canon PowerShot S400 Shutter Button Assembly Replacement, Canon PowerShot S400 Shutter Button Assembly Replacement: step 1, image 1 of 2 Canon PowerShot S400 Shutter Button Assembly Replacement, Canon PowerShot S400 Shutter Button Assembly Replacement: step 1, image 2 of 2
      • Unless otherwise stated,a #00 philips screwdriver will be used to remove screws.

      • Remove the 4.75mm screw located in the top right corner of the backside of the camera.

      • Remove the four # screws located on the bottom of the camera.

      Add Comment

    2. Canon PowerShot S400 Shutter Button Assembly Replacement: step 2, image 1 of 3 Canon PowerShot S400 Shutter Button Assembly Replacement: step 2, image 2 of 3 Canon PowerShot S400 Shutter Button Assembly Replacement: step 2, image 3 of 3
      • Remove the two screws located on the right side of the camera.(the side with the USB adaption plug)

      • Remove the four screws on the left side of the camera.

      • This will release a small metal plate. Remove this plate.

      Add Comment

    3. Canon PowerShot S400 Shutter Button Assembly Replacement: step 3, image 1 of 3 Canon PowerShot S400 Shutter Button Assembly Replacement: step 3, image 2 of 3 Canon PowerShot S400 Shutter Button Assembly Replacement: step 3, image 3 of 3
      • There is a small black plastic piece that sits above the lens underneath the camera case. This plastic piece may fall out when you remove the cases; recover the piece and save it.

      • Now separate the front and back camera casings.

      Add Comment

    4. Canon PowerShot S400 Shutter Button Assembly Replacement: step 4, image 1 of 1
      • Using a spudger, carefully pry the shutter button assembly from the camera.

      • Install the replacement shutter button assembly.

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

System

Member since: 09/24/09

2,562 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 32