Canon PowerShot S410 Back Cover Replacement

Step 1 Canon PowerShot S410 Back Cover Replacement



• Turn the camera with the bottom side facing up.
• Locate the panel labeled "Batt. Open"
• Place your finger on the panel and slide it in the direction of the arrow.
• The slot will swing open revealing the battery pack.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2

• Rotate the camera so that the slot is horizontal.
• Pull the orange lever and the battery will spring out slightly.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Grasp battery and fully pull out of slot
• When placing the new battery back in the slot, the arrow on the battery must align with the arrow on the camera.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Start by laying the camera flat with the LCD screen facing up.
• Remove the 3.8mm screw in the upper right corner.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• Position the camera with the bottom facing up.
• Remove the 4.8mm screw.
• Remove the two 2.3mm screws.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 6
• Position the camera so that the rubber "AV Out Digital" tab is facing upward.
• Slide this rubber tab out of the way to reveal the bottom screw.
• Remove the two 3.7mm screws.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 7
• Turn the camera with the back side facing you.
• Grip the edges of the back plate, and carefully slide it off.
• If there is any resistance in movement, double check there are no screws left in the chassis.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview