Introduction
Use this guide to replace a dysfunctional back cover.
What you need
-
-
Remove the two 4.5mm (.18in) long black screws from the side cover using a #00 Phillips screwdriver.
-
-
-
On the bottom, remove the last long screw with the Phillips Screwdriver.
-
Use tweezers to lift the panel.
-
-
-
Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
-
Use tweezers to lift the panel.
-
-
-
Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
-
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
