Skip to main content

Hand Mixer

What you need

  1. Hand Mixer, Hand Mixer: step 1, image 1 of 1
    • Remove the metal mixers.

  2. Hand Mixer: step 2, image 1 of 1
    • Cut the power cable. Dispose of the plug separately (mixed waste).

  3. Hand Mixer: step 3, image 1 of 3 Hand Mixer: step 3, image 2 of 3 Hand Mixer: step 3, image 3 of 3
    • Unscrew the case.

    • If you cant's reach any screws, use a hammer aiming at the very spot where the screw sits.

    • Open the case.

  4. Hand Mixer: step 4, image 1 of 1
    • Unscrew the power supply cable.

  5. Hand Mixer: step 5, image 1 of 2 Hand Mixer: step 5, image 2 of 2
    • Remove the printed wiring board (PWB) and the capacitor.

    • Cut all wires connected to the PWB.

  6. Hand Mixer: step 6, image 1 of 1
    • Remove the motor.

  7. Hand Mixer: step 7, image 1 of 3 Hand Mixer: step 7, image 2 of 3 Hand Mixer: step 7, image 3 of 3
    • Remove the fixture for the mixers.

    • Separate metal from plastic parts.

  8. Hand Mixer: step 8, image 1 of 1
    • Separate the remaining materials according to their type and go on with the appropriate data sheet (e.g. aluminium, ferrous metals, plastic, further PWBs, etc.).

    • Make sure the plastic parts are completely free of metal pieces.

Finish Line

Elisabeth Herbeck

Member since: 09/24/15

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 57