How to Disassemble Hand Mixers

Introduction

Dismantling and Recycling Centre (DRZ)

Katharina Lenz, Vienna / Austria

This is a general guide for most mixers.

Health & Safety

Dismantling of mixers doesn't include any harmful steps. Nonetheless workers should wear personal protection equipment like gloves, goggles, apron and robust shoes.

Note: As the construction of mixers can differ, the dismantling steps mentioned below can vary in their order. However, the described steps show what parts the removal should focus on.

What you need

Step 1 How to Disassemble Hand Mixers

• Remove the metal mixers.
Step 2

• Cut the power cable. Dispose of the plug separately (mixed waste).
Step 3
• Unscrew the case.
• If you cant's reach any screws, use a hammer aiming at the very spot where the screw sits.
• Open the case.
Step 4
• Unscrew the power supply cable.
Step 5
• Remove the printed wiring board (PWB) and the capacitor.
• Cut all wires connected to the PWB.
Step 6
• Remove the motor.
Step 7
• Remove the fixture for the mixers.
• Separate metal from plastic parts.
Step 8
• Separate the remaining materials according to their type and go on with the appropriate data sheet (e.g. aluminium, ferrous metals, plastic, further PWBs, etc.). Make sure the plastic parts are completely free of metal pieces.

Author

with 3 other contributors

Elisabeth Herbeck

Member since: 09/24/15

10 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview