Skip to main content

Introduction

This is a dismantling manual for a cylindrical design vibration motor on the basis of the Nokia Lumia 930, according to get the tungsten.

  1. You see the front and the back of the Nokia Lumia 930, as well the removed sim card slot First remove the sim card slot at the very top Pull the sim card slot out of the phone using your fingernail
    • You see the front and the back of the Nokia Lumia 930, as well the removed sim card slot

    • First remove the sim card slot at the very top

    • Pull the sim card slot out of the phone using your fingernail

  2. The backside cover is clipped onto the phone
    • The backside cover is clipped onto the phone

    • Place some tweezers in the sim card hole and lever upwards until the back panel pops out

    • Wedge a thin tool into the opening made in the previous step. Slide it along the edges to completely remove the back panel from the phone’s frame

  3. Loose one T4 screw to remove the battery connector strap
    • Loose one T4 screw to remove the battery connector strap

  4. Remove the ten T4 screws that secure the motherboard cover to the phone Use a flat tool to pry the motherboard cover apart from the phone frame (with the battery still in the phone) After removing the motherboard cover, use a thin tool to lift up the battery and remove it
    • Remove the ten T4 screws that secure the motherboard cover to the phone

    • Use a flat tool to pry the motherboard cover apart from the phone frame (with the battery still in the phone)

    • After removing the motherboard cover, use a thin tool to lift up the battery and remove it

  5. Use a thin tool to loose the camera connector (circle), the six ribbon cables (squares) and the two antenna cables (arrows) Remove the motherboard with a thin tool
    • Use a thin tool to loose the camera connector (circle), the six ribbon cables (squares) and the two antenna cables (arrows)

    • Remove the motherboard with a thin tool

  6. Use a thin tool to remove the daugtherboard Use a thin tool to remove the daugtherboard
    • Use a thin tool to remove the daugtherboard

  7. Use a pair of tweezers to remove the vibration boot that covers the module Use a thin tool to remove the vibration motor
    • Use a pair of tweezers to remove the vibration boot that covers the module

    • Use a thin tool to remove the vibration motor

  8. The part that's pure tungsten is the weight at the front of the motor shaft
    • The part that's pure tungsten is the weight at the front of the motor shaft

    • Try to remove the weight with pliers

Finish Line

Andre

Member since: 05/08/2018

3 Guides authored

Team

iFixit EU Team Member of iFixit EU Team

Community

7 Members

22 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 26

ABOUT RIC