Introduction
Removing these panels allows further access to the GameCube's components.
What you need
-
-
Turn over the Gamecube so that the bottom side is facing up.
-
Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws.
-
-
-
With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up.
-
-
-
Gently press down on the clips located on either side of the the back panel, as shown, and carefully remove it from the main part of the device.
-
-
-
Use a Phillips screwdriver to remove the two 2 screws(circled in red) that are located on the back of the control port.
-
Carefully separate the gray outer casing of the control port and the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.