Skip to main content

Introduction

Dismantling and Recycling Centre (DRZ)

Katharina Lenz, Vienna / Austria

Health & Safety

Dismantling doesn't include any harmful steps. Nonetheless workers should wear personal protection equipment like gloves, goggles, apron and robust shoes.

Note: This is a general guide for most ovens. As the construction can differ, the dismantling steps mentioned below can vary in their order. However, the described steps show what parts the removal should focus on.

  1. Remove the screws on the top cover. Remove the top cover.
    • Remove the screws on the top cover.

    • Remove the top cover.

  2. Remove the grounding wire. Pry off the plugs.
    • Remove the grounding wire.

    • Pry off the plugs.

  3. Remove the screws of the cover.
    • Remove the screws of the cover.

    • Remove the cover.

  4. Unplug the switches. Remove the controll buttons Remove the screws on the button fixtures.
    • Unplug the switches.

    • Remove the controll buttons

    • Remove the screws on the button fixtures.

  5. Unplug the adjusting controllers. Remove all the adjusting controllers.
    • Unplug the adjusting controllers.

    • Remove all the adjusting controllers.

  6. Remove all the screws from the bottom case.
    • Remove all the screws from the bottom case.

  7. Remove the metal case.
    • Remove the metal case.

  8. Unscrew and remove the fixtures insulation.
    • Unscrew and remove the fixtures insulation.

  9. Remove the screws from the fan assembly. Lift off the fan wires.
    • Remove the screws from the fan assembly.

    • Lift off the fan wires.

  10. Cut the plastic rings holding the the wires. Unscrew the ground cables.
    • Cut the plastic rings holding the the wires.

    • Unscrew the ground cables.

  11. Pull off the connections. Cut the wires.
    • Pull off the connections.

    • Cut the wires.

  12. Remove the screws from the case.
    • Remove the screws from the case.

  13. Remove the screws from the door. Pry off the hinge. Remove the door.
    • Remove the screws from the door.

    • Pry off the hinge.

    • Remove the door.

  14. Unscrew and remove the bottom. Unscrew and remove the bottom.
    • Unscrew and remove the bottom.

  15. Remove the screws from the front.
    • Remove the screws from the front.

  16. Peel off the rubber sealing.
    • Peel off the rubber sealing.

  17. Remove the insulation wool.
    • Remove the insulation wool.

  18. Remove the metal rails that held the insulation wool.
    • Remove the metal rails that held the insulation wool.

  19. Remove the screws from the fan.
    • Remove the screws from the fan.

  20. Empty the case.
    • Empty the case.

  21. Separate the remaining materials according to their type and go on with the appropriate data sheet (e.g. aluminium, ferrous metals, plastic, further PWBs, etc.).
    • Separate the remaining materials according to their type and go on with the appropriate data sheet (e.g. aluminium, ferrous metals, plastic, further PWBs, etc.).

    • Make sure the plastic parts are completely free of metal pieces.

Finish Line

Tobias Isakeit

Member since: 03/15/2018

21 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 67

ABOUT RIC