How to disassemble the PEAQ TFT32NUMUNE TV set

Step 1 Opening

• Place the TV screen side-down.
• Using the PH#1 screwdriver, begin to loose the two screws located in the external connectors' square (highlighted in green boxes).
• Then, with the PH#2 screwdriver, continue to loose the sixteen screws of the back-casing (highlighted in green boxes).
• Work your way around the TV until you can pull the back cover off.
Step 2 Removal of Printed Circuit Boards (PCB)



• Remove cables: Disconnect all sixteen connectors (highlighted in red boxes) and separate the tapes (highlighted in the blue box) used to fix cables to the metal casing.
• Remove Printed Circuit Boards (PCB):
• Using PH#1 screwdriver, begin to loose the twenty-one screws (highlighted in green boxes).
• Using J1 screwdriver, continue to loose the last two screws located in the bottom PCB protected with a double metal casing.
Step 3 Removal of Speakers
• Remove the speakers by extracting them manually from their mountings (blue boxes).
Step 4 Removal of Liquid Crystal Display (LCD)
• Place the TV screen up and remove the front frame which is already exposed.
• Using PH#1 screwdriver, begin to loose the twelve screws of the inner frame.
• Starting at the bottom-right corner, continue to work your way around the frame counterclockwise until you can pull the frame off.
• Remove the LCD panel which is already free.
Step 5 Removal of Polarized Foils
• First, using a PH#1 screwdriver, loose the four screws located in the bottom of the frame (green boxes).
• Then, with slotted screwdriver, begin to lever the fourteen clips of the inner frame starting at the bottom of the TV.
• Continue to work your way around the frame counterclockwise until you can pull the frame off.
• Remove the already exposed polarized foils.
Step 6 Removal of Backlights (LED)
• Use your fingers to pry the two connectors of the PCBs.
• Using PH1 screwdriver, loose the ten screws used to fix the LEDs containing metal components.
• Take the two metal parts where the LED PCBs are located.
• Using PH1 screwdriver, loose the two side screws use to fix the PCBs to the metal part.
• Use a slotted screwdriver to trip off the PCB that is glued to the mounting.
• Repeat the previous couple of steps with the other metal part.
Step 7 TV Dismantling fractions
• All fractions obtained after TV dismantling.

Author

with 3 other contributors

Amaia

Member since: 03/23/16

11 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview