/
EN
/

Site Navigation

Your Account

Choose Language

PSP Go Bottom Plate Replacement

Introduction

Use this guide to remove the PSP Go's bottom plate!

What you need

  1. PSP Go Bottom Plate Replacement, PSP Go Bottom Plate Replacement: step 1, image 1 of 2 PSP Go Bottom Plate Replacement, PSP Go Bottom Plate Replacement: step 1, image 2 of 2

    • Unscrew the four Phillips screws on the back of the PSP Go.

    • Rotate the PSP so you can see the top of the device.

    • Unscrew the two Phillips screws next to the volume buttons.

  2. PSP Go Bottom Plate Replacement: step 2, image 1 of 2 PSP Go Bottom Plate Replacement: step 2, image 2 of 2

    • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

    • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

    • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

  4. PSP Go Bottom Plate Replacement: step 3, image 1 of 1

    • Pull the top cover upwards gently from its housing.

  5. PSP Go Bottom Plate Replacement: step 4, image 1 of 2 PSP Go Bottom Plate Replacement: step 4, image 2 of 2

    • Remove the two Phillips screws holding the bottom plate.

    • Gently lift the bottom plate away from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

System

Member since: 09/24/09

2,562 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 14