Panasonic Lumix DMC-TZ5 Button Board Replacement

Step 1 Panasonic Lumix DMC-TZ5 Button Board Replacement

• Remove the battery and memory card from the device.
Step 2

• Remove 4 screws from the right side of the camera.
• There are two 3.4mm screws at the top.
• There are two 2.2mm screws at the bottom.
Step 3
• Remove the single 3.4mm screw on the left side of the camera.
Step 4
• Remove 5 screws from the base of the camera.
• There are two 2.2mm screws next to the battery compartment.
• There are three 4mm screws around the tripod mount.
Step 5
• Slowly slide the back cover away from the device
• The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.
Step 6
• Detach both ribbon cables using a spudger.
• Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
Step 7
• Remove the back casing from the camera.
Step 8
• Use the spudger to remove the ribbon cable connecting the lens casing to the circuit board by lifting up the black clip.
• Carefully remove the function switch cover. This unit snaps on and off.
Step 9
• Carefully unsnap the front logic board from the rear logic board using a spudger.
Step 10
• Slide the entire top part of the camera that is attached to the logic board, horizontally away from the camera.
Step 11
• Remove the ribbon cable from the top connection panel by unlocking the black clip with a spudger.
• This leaves you with the logic board and the top connection panel separate and free from the camera

Author

with 1 other contributor

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview