Skip to main content
/

Changes to Step #6

Edit by Gergana

Edit approved by Gergana

Before
After
Unchanged

Step Lines

[title] Removal of Backlights (LED)
-[* black] Use your fingers to pry the two connectors of the PCBs.
-[* black] Using PH1 screwdriver, loose the ten screws used to fix the LEDs containing metal components.
+[* black] Use your fingers to pry open the two connectors of the PCBs.
+[* black] Using PH#1 screwdriver, loose the ten screws used to fix the LEDs containing metal components.
[* black] Take the two metal parts where the LED PCBs are located.
- [* black] Using PH1 screwdriver, loose the two side screws use to fix the PCBs to the metal part.
- [* black] Use a slotted screwdriver to trip off the PCB that is glued to the mounting.
+ [* black] Using PH#1 screwdriver, loose the two side screws used to fix the PCBs to the metal part.
+ [* black] Use a slotted screwdriver to separate the PCB that is glued to the mounting.
[* black] Repeat the previous couple of steps with the other metal part.