iPad Wi-Fi Home Button Switch Replacement

Step 1 iPad Wi-Fi Home Button Switch Replacement




• If your display glass is cracked, keep further breakage contained and prevent bodily harm during your repair by taping the glass.
• Lay overlapping strips of clear packing tape over the iPad's display until the whole face is covered.
• This will keep glass shards contained and provide structural integrity when prying and lifting the display.
• Do your best to follow the rest of the guide as described. However, once the glass is broken, it will likely continue to crack as you work, and you may need to use a metal prying tool to scoop the glass out.
• Wear safety glasses to protect your eyes, and be careful not to damage the LCD screen.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2



• Insert a metal spudger between the top edge of the display assembly and the rear panel assembly.
• Rotate the spudger away from you to release the tabs along the top edge of the display.
• Insert a second metal spudger between the top edge of the display assembly and the rear panel assembly to keep the tabs from snapping back into place.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• With one spudger, work your way along the right edge of the iPad.
• The front panel is held to the aluminum back by metal clips on the top, bottom, and left sides. The right side has plastic tabs which slide into recesses in the backplate.
• Once the clips are released, lift the left side of the front panel up and slide it to the left to clear the tabs from the aluminum backplate.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Lift the display assembly away from the rear panel assembly by its bottom edge.
• Do not attempt to remove the display at this time, as it is attached to the rear panel assembly.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• In the following steps, you will disconnect the three cables attaching the display assembly to the logic board. The cables are for the following components:
• Digitizer
• Ambient Light Sensor
• Display Data Cable
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 6
• Use the edge of a plastic opening tool to flip up the retaining flaps holding the digitizer ribbon cables in their sockets on the logic board.
• Be sure you are flipping up the retaining flap, not the socket itself.
• Pull the digitizer ribbon cables straight out of their sockets.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 7
• Use a plastic opening tool to remove the ambient light sensor connector from its socket by gently prying upward.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 8
• Disconnect the display data cable from the main board by flipping up the metal retainer by its black plastic pull tab.
• Pull the cable connector away from its socket.
• Pull the connector parallel to the face of the logic board.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 9
• Remove the display assembly from the rear panel assembly.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 10
• Remove the two T5 Torx screws securing the home button switch board to the display frame.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 11
• Remove the home button switch board from the display frame.
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

System

Member since: 09/24/09

2,562 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview